Protect Legs and Belt Conveyors with our Versatile Hazard Monitoring Equipment

Belt Speed
The speed sensor is mounted on the boot shaft of the leg or tail shaft of a belt conveyor.
If the belt slows down to 90% because of loose belt or plug overload and alarm horn goes
off and feed equipment can be interlocked to shut down. If belt slows down to 80% it will
shut down to prevent the belt from burning off.

Belt Alignment for Legs
(4) Rub blocks are installed. (2) at the head section and (2) at the boot section. If belt gets
out of line and rubs on side alarm horn goes off to notify the operator.

Belt Alignment for Belt Conveyors
(4) Rub blocks are installed. (2) at the head section and (2) at the tail section. If belt gets
out of line and rubs on side alarm horn goes off to notify the operator. You may need to
contact your millright contractor to install rub blocks as each are built different.

Bearing Temps
(4) Bearing Temp sensors are installed. (2) on head bearings and (2) on boot bearings. If
bearing becomes overheated alarm horn goes off to notify the operator. If leg has idler
bearings you have the option of installing sensors on those also.

Motor Amps
A CT (Current Transformer) is installed at motor starter on one of the 3phase lines feeding
the motor. This then sends a signal to the meter on panel to show motor amperage. Option is
available to have an alarm if motor is over amps.